TM 9-2330-381-14
4-41. SUSPENSION CYLINDER (CONT)
32.
Install block clamp (9) and secure with screw (8) and, if necessary, self-locking nut (10) (#4 bogie only).
33.
Remove caps/plugs installed and connect two air hoses (11) to fittings (12).
34.
Using one person to hold both hydraulic hoses (5) in place, install two hose clamps (18) on hydraulic hoses (5) at
positions previously marked. Secure hose clamps (18) in place by installing two capscrews (22), washers (21),
and locknuts (20).
35.
Route both hydraulic hoses (5) and air hoses (11) along each respective side of upper suspension arm (17) and
place each set of hoses into hose shields (16 and 15).
36.
Check position of shields (16 and 15) on each set of hoses. Move each hose (5 and/or 11) as required so that
marks previously applied are alined with edges of both shields (16 and 15).
4-190