TM 9-2330-381-14
CYLINDER STOP ADJUSTMENT
NOTE
Steering stop blocks and associated hardware are not used on vehicles with
manufacturer's serial numbers 526 and subsequent. Manufacturer's serial number
is stamped in front of platform main beam under the gooseneck. On units without
cylinder stops, this procedure is unnecessary.
1.
On both cylinders (1), measure distance (dimension "A") between cylinder piston attaching point on #5 steering
plate (12) and piston end of cylinder body. If dimension "A" is the same for both cylinders, go to step 3. If
dimension "A" is not the same, go to step 2.
Change 1 4-273