TM 9-2330-381-14
5-15. LOWER SUSPENSION ARM (CONT)
INSTALLATION
1.
Using two people to maneuver hydraulic jack supporting lower suspension arm (1), aline lower suspension arm
(1) with upper suspension arm (5).
2.
Apply antiseize compound to inside bore of assembly joint for both upper and lower suspension arms (5 and 1)
and to exterior of shouldered shaft (6).
3.
Insert smaller end of shouldered shaft (7) through larger bore in upper suspension arm (5) and into bore in lower
suspension arm (1) until shaft movement is stopped by lip at bearing oil seal.
4.
Using a 0.015-inch blade, on 20-blade feeler gage set, inserted in smaller bore of upper suspension arm (5),
carefully adjust position of lip of bearing oil seal up onto small end of shouldered shaft (7).
5-50