TM 5-2420-230-10
Observe local laws and regulations when transporting vehicle on public road. Use suitable truck or trailer for transporting
vehicle. For specific shipping requirements, refer to Appendix E.
Always load and unload IHMEE on solid, level surfaces, using a loading dock or ramp.
Select a low gear and 4WD mode while driving up or down ramps.
Do not operate any functions other than travel and service brakes when traveling up or down ramps, as this will unbalance
vehicle.
When positioned on trailer or flatbed, tie down vehicle using tie-down points:
(1)
Position vehicle and chock all tires.
(2)
With the ignition switch in the IGN position, set MODE CONTROL switch to C130/LIMP and wait for
suspension to lower.
(3)
Turn each airbag pneumatic control valve off.
(4)
Turn ignition switch OFF.
(5)
Secure vehicle using tie-down points.
(6)
Ensure you know height and weight of IHMEE on trailer.
Maintenance Safety.
Section III.
Do not allow personnel to perform maintenance on FEL or backhoe with buckets loaded and/or raised.
Failure to comply may result in injury and/or death to personnel.
Before performing any work on the IHMEE, prepare and isolate vehicle. It is important to understand all service procedures
before undertaking any work.
(1)
Ensure vehicle is positioned on level ground.
(2)
(3)
Change 1