TM 5-2420-230-10
This Task Covers:
a. Removal
b. Installation
c. Follow-On Maintenance
INITIAL SETUP
References
Test Equipment
None
None
Equipment Conditions
Tools and Special Tools
TM or Para
Condition Description
Vehicle prepared for servicing (Do
not install FEL maintenance arm).
Materials/Parts
Drawings Required
None
Personnel Required
MOS 21J, Construction Engineering Operator
Estimated Time to Complete
6 min.
a. Removal.
(1)
Remove locking clip (1) and retaining pin (2).
(2)
Raise ripper arm (3) to horizontal position and
replace retaining pin (2).
(3)
Use hammer to drive ripper tooth (4) off of
ripper arm (3). Discard tooth.
b. Installation.
(1)
Position new ripper tooth (4) on ripper arm (3).
(2)
Use hammer to drive ripper tooth (4) fully onto
ripper arm (3).
(3)
Remove locking clip (1) and retaining pin (2),
and lower ripper arm (3) to down position.
(4)
Install retaining pin (2) and locking clip (1).
c. Follow-On Maintenance.
Remove "Do Not Operate" tag from ignition switch.
END OF TASK
Change 1