TM 55-1925-284-14&P
0017 00
5. Remove the breather (figure 2, item 5) and the oil overflow plug (figure 2, item 6).
ASSEMBLY
1. Wrap the male pipe threads of the oil drain plug (figure 2, item 3) with antiseizing tape and install the oil drain
plug in the blower (figure 2, item 4).
WARNING
Do not allow hydraulic fluid, engine oil, or cleaning solvents to come in contact
with unprotected skin or eyes. Prolonged skin contact can cause illness or injury.
Eye contact can cause serious injury. Always wear chemical protective gloves
and goggles when handling hydraulic fluid, engine oil, and cleaning solvents.
Failure to follow these precautions can result in illness or serious injury.
2. Fill the blower (figure 2, item 4) with new oil (table 1) through the breather (figure 2, item 5) until the oil runs
out of the overflow (figure 2, item 6).
Table 1. Recommended Oil Grades
Temperature
SAE
Above 90 F (32 C)
50
32 F to 90 F (0 C to 32 C)
40
0 F to 32 F (-18 C to 0 C)
30
3. Wrap the male threads of the breather (figure 2, item 5) and the overflow plug (figure 2, item 6) with antiseizing
tape and install them into their respective holes.
WARNING
Cleaning solvent is flammable and its vapor is potentially explosive. Do not use
cleaning solvent in the vicinity of spark, open flame, or excessive heat. Do not
use cleaning solvent in unventilated spaces. Failure to follow these precautions
can result in death or serious injury.
4. Use clean wiping rags and dry cleaning solvent to clean the work area.
0017 00-4