TM 55-4920-384-13&P
AVIATION UNIT MAINTENANCE INSTRUCTIONS
Section I. PREPARATION FOR INSTALLATION STORAGE OR SHIPMENT
Information for preparation for installation stor-
tion III.
Section II. INSTALLATION
Not Applicable.
Section III. INSPECTION AND SERVICING
3-1. Operators must perform the
following in-
spections and servicing daily as specified in
PROCEDURES
INTERVALS
After
During
Before
Operation
Operation
Operation
Visual Inspection. Make a general in-
spection of the entire unit for obvious defi-
ciencies, such as oil or fuel leaks, loose or
missing bolts, nuts, screws, loose con-
nections, broken wires, and any damage
that may have occured since the equipment
was last operated. Correct or report any
deficiencies to AVIM maintenance.
Tampering. Inspect the test stand for evi-
dence of tampering or damage. Do not oper-
ate the unit until all defects are corrected or
reported to AVIM.
Fuel. Check the fuel supply. See that the
fuel tank is full.
Leaks. Inspect for leaks, paying particular
attention to the fuel line and connections.
Correct all deficiencies noticed or report to
AWIM.