TM 55-4920-390-13&P
1-6. LAMP ASSEMBLY. The hand-held lamp assembly is at the free end of its 9' cable. It consists of a housing on a
pistol grip handle with trigger switch (S 301) for the DC power to the electronics section. Storage is provided in the
bottom of the case. In the housing are the following -
a)
The source lamp appropriately mounted in its reflector. (V 301)
b)
The "Diode Package" (Part #B2726).
c)
Multi-turn Dial" for setting of locked oscillator flash rate. (R 302)
d)
Single turn pot/switch assembly and knob for vernier adjustment of oscillator rate to achieve optimum pattern
of blade tip targets. (R 301, S 302) Activation of switch (knob full CCVW disables oscillator so that lamp
flashes once per external command, causing unit to operate like previous Strobex Blade Tracker.
1-7. CABLE STORAGE. The top half of
the case is
provided with a
hinged inner lid (See Fig. 1-1, b
and c)
which,
when closed, forms a compartment for storage of two each 40' cables (one for DC power and one for signal).
Figure 1-5. Cable and Lamp Storage And Circuit Compartment.
1-6