TM 9-1550-416-14&P.
CHAPTER 3
OPERATOR MAINTENANCE
Section I. INTRODUCTION
GENERAL.
3-2.
REPAIR PARTS,
3-1.
Repair parts are listed in appendix D of this manual. All of
This chapter contains information and instructions for per-
the items contained in the field support kit are either part of the
forming assembly and maintenance procedures.
aircraft kit, or the support equipment.
Section II. SERVICE UPON RECEIPT
Open the container from the top, remove the card-
a.
GENERAL.
3-3.
board retainers and all the wing and fuselage sections by lift-
ing the entire assembly from the box. If one wing or fuselage
This section contains procedures to be used by personnel
is needed bend the cardboard retainers aside and remove as
upon receiving aerial target, transmitter, support equipment,
needed.
and field support kits.
b.
Remove the sub kit container.
Remove cardboard forms from wing and fuselage
c.
CHECKING UNPACKED EQUIPMENT.
3-4.
Inspect the equipment for damage incurred during
a.
shipment. If the equipment has been damaged, report the
UNPACK AIRCRAFT KIT/FQM-117 C-1.
3-7.
damage on DD Form 6, Packaging Improvement Report.
Check the equipment against the packing slip to see
b.
a.
Open the container from the end and remove the
if the shipment is complete. Report all discrepancies in
three kit boxes and the sub kit container.
accordance with the instructions of DA PAM 738-750.
Open the kit and sub kit boxes. Verify contents per
Check to see whether the equipment has been
b.
c.
modified.
UNPACK TRANSMITTER KIT.
UNPACK GSE KIT.
3-8.
3-5.
a.
a.
Open container and remove containerized GSE/
tainers.
FOB
b.
Open each container and verify contents per appen-
Remove accessory equipment.
b.
dix D.
c.
3-6.
UNPACK AIRCRAFT KIT/FQM-117 B-1
NOTE
Only the top fuselage in each kit has the
receiver and the servo/battery modules
shipped in their respective cavities.
3-1