TM 9-1550-416-14&P
(10) Place aluminum foil ball in fuselage. (See fig.
screw holes in wing and fuselage are free from foam. Place
3-9.) Loosely crumple one sheet of
aluminum foil into a
ball
wing on fuselage. Put a washer on each wing mounting bolt
approximately the size of a baseball. Place the ball of foil in the
and insert through the bottom of the fuselage. Place a washer
forward payload bay of the fuselage.
on each protruding bolt shank before installing wing nut.
Tighten wing mounting bolts "finger-tight" (approximately
(11) Install wing assembly. (See fig. 3-9.) Ensure
10-12 in/lbs).
Figure 3-9. Wing assembly installation.
(12) Connect control snap links.
(a) Connect throttle pushrod snap link to en-
Figure 3-10. Snap link attachment to throttle.
3-10