TM 9-2320-209-10-1
FRAME 2
1.
Step on and press clutch pedal (1) all the way down.
Make sure that FRONT TRANSMISSION gearshift lever (2) is in N position.
2.
Place POWER TAKEOFF SHIFTS lever (3) in LOW position.
3.
4.
Set handbrake lever (4) off to down position.
The front winch will pull vehicle forward
Let clutch pedal (1) come up slowly.
5.
and wind winch line onto drum.
Step on brake pedal (5) and press down lightly to make sure of a tight, neat wind.
6.
NOTE
Make sure that first layer of winch line goes onto drum
in order and that each additional layer starts back across
drum. If necessary, use wooden block to push or hammer
line closely wrapped. If truck is equipped with a load
winding device, this will not be necessary.
GO TO FRAME 3
4-73