TM 9-2320-211-10-1
I
FRAME 4
Pull out level wind lock knob (1) , turn it 90, and let it go.
1.
2.
Lift CLUTCH CONTROL lever (2) to DISENGAGE position shown on data
plate (3).
3.
Take
out pin (4) from WINCH SHIFT control lever (5) .
Move
4.
WINCH SHIFT control lever (5) to UNWIND position shown on data
plate
(6).
Move
5.
cable tensioner valve control ( 7) to OFF position,
WARNING
Always wear protective gloves when handling winch cable.
Do not let winch cable slip through hands. Rusty or broken
wires can cause serious injury.
Move CLUTCH CONTROL lever (2) to ENGAGE position.
6.
Drum (8) will now turn and unwind cable (9) .
7.
CAUTION
Do not operate winch with less than four turns of cable
on drum. The cable clamp screw alone will not hold against
a load.
NOTE
Keep tension on cable while drum is turning to prevent kinks
or snarled cable on drum.
After enough cable is unwound, move CLUTCH CONTROL lever (2) to
8.
DISENGAGE position.
Move WINCH SHIFT control lever (5) to NEUTRAL position.
9.
TA 053965
4-168