TM 9-2320-211-10-1
RAME 4
Positioning outriggers for heavy rear lift:
(a)
Take pin (1) from end of L-shaped retaining pin (2).
Take L-shaped retaining pin (2) out of outrigger frame tube (3) .
(b)
(c)
Pull outrigger (4) out until it hits stop (5).
(d)
Turn outrigger (4) toward the ground.
(e)
Aline holes in outrigger (4) and frame tube (3).
(f)
Put L-shaped retaining pin (2) through holes.
Place pin (1) through hole in end of pin (2) and close pin.
(g)
(h)
Turn base (6) until it reaches the ground.
(i)
Put jack adjusting bar (7) in hole in adjusting screw (8).
Turn bar (7) until there is a little pressure between base (6) and
(j)
ground.
(k)
Do steps (a) through (j) again for three other outriggers.
GO TO FRAME 5
TA 053978
4-183