TABLE 3-2. TROUBLESHOOTING
TEST OR INSPECTION
6. Engine overheats, according to temperature gage.
Step 1. Check temperature gage. Observe preceding warning.
If reading is above 200F, check cooling system. Add coolant, as required.
If low, add proper grade of oil to full mark on dipstick (see LO
Step 3. Other causes.
Notify organizational maintenance.
7. Low engine oil pressure.
Step 1. Check engine oil level.
If low, add proper oil to full mark on dipstick (see LO 2320-211-12).
Step 2. Check for correct oil for climate conditions.
If not correct, drain oil from crankcase. Replace with proper oil (see LO
8. Excessive oil consumption.
Step 1. Check for oil leaks.
Perform visual engine check. If leak is detected, notify organizational
Step 2. Check log book for date of last oil change to determine probable oil weight in
If necessary, change oil (see LO 9-2320-211-12).