TM 9-2320-269-10
USING THE AUGER - CONTINUED
OPERATION - CONTINUED
CAUTION
Make sure derrick hydraulic leg is fully retracted before stowing auger. If
not fully retracted, the equipment may be damaged.
13. When drilling is completed, return the auger (1) to the stowed position by:
a. Fasten end of wind-up-cable (2) over hook (3) on auger shaft clutch (4). Make sure cable (2) is
properly secured.
b. Raise derrick leg (5) to 450 angle.
c.
Push auger control handle (6) down until auger (1) locks into auger lock (7).
TA 222621
2-134