TM 9-2320-279-10-2
M984E1 General Operating Procedures (Cont)
(23) Set POWER switch (14) to ON.
(24) Push LATCH switch (3) to ON and release.
(25) Make sure recovery area is clear of personnel.
NOTE
Recheck your rigging.
(26) When using remote control, set HEAVY DUTY WINCH switch (11) to
ON. When using manual control, set HIGH IDLE switch (4) to ON.
Engine idle should increase to approximately 1500 rpm.
NOTE
If M984E1 tires do not provide enough traction to
(27) Move WINCH control lever (5) to IN and recover mired vehicle.
(28) When mired vehicle is fully recovered, move WINCH control lever (5)
to OUT to allow enough slack in winch cable to disconnect.
(29) When using remote control, set HEAVY DUTY WINCH switch (11) to
OFF. When using manual control, set HIGH IDLE switch (4) to OFF.
(30) If tow
spades were used, remove and stow tow
spades (para 2-66b).
2-111