TM 9-2320-279-10-2
M984E1 General Operating Procedures (Cont)
WARNING
Driveshafts can weigh up to 100 lb (45 kg). Properly support driveshafts when removing screws. After
screws and brackets are removed, driveshaft can fall and cause serious injury to personnel.
NOTE
To remove driveshaft screw, use wrench located in PLS BII storage box.
Driveshaft ends at No. 3 axle and transfer case are removed the same way.
(30) Soldier A supports No. 3 axle driveshaft (43) while Soldier B removes four screws (44) and two brackets
(45).
(31) Remove No. 3 axle driveshaft (43) from flange (46).
Change 2 2-186.11