TM 9-2320-279-10-2
M984E1 General Operating Procedures (Cont)
WARNING
Driveshafts can weigh up to 100 lb (45 kg). Properly support driveshafts when removing screws. After
screws and brackets are removed, driveshaft can fall and cause serious injury to personnel.
NOTE
To remove driveshaft screws, use wrench located in PLS BII stowage box.
Driveshaft ends at No. 2 axle and transfer case are removed the same way.
(34)
Soldier A supports No. 2 axle driveshaft (41), while Soldier B removes four screws (42) and two brackets (43).
(35)
Remove No. 2 axle driveshaft (41) from flange (44).
WARNING
Steering axles must be turned straight forward or disabled vehicle will not track properly, causing vehicle
damage or injury to personnel.
(36)
Turn steering axles straight forward and install lock on steering column (TM 9-2320-364-10).
Change 2 2-186.31