TM 9-2320-285-10
2-14.
OPERATING PROCEDURES (Continued)
g. Tilting Cab 45 Degrees (continued).
(6)
Carefully and slowly rotate control valve counterclockwise until full weight of cab rests upon safety bar.
(7)
Rotate control valve clockwise against stop.
h. Lowering Cab to Normal Operating Position.
WARNING
Stay out from under cab unless safety bar is supporting full weight of cab. Failure to follow this procedure
could result in severe injury from falling cab.
(1)
With cab tilted 45 degrees, move pump handle up and down to raise cab just enough to take weight of cab
off safety bar.
(2)
Remove pump handle and use it to lift safety bar out of notch.
NOTE
Do not allow cab to fall quickly; velocity fuse will set and cab will not lower.
(3)
Slowly rotate control valve counterclockwise to bring cab down slowly.
(4)
After safety bar is past its first notch, remove pump handle and stand aside as cab lowers.
(5)
When cab has stopped moving, rotate control valve fully counterclockwise. Be sure cab latch hooks fully
engage latch brackets.
2-46