TM 9-2320-360-10
Table 3-1. Troubleshooting (Cont)
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
3. WINCH OPERATES TOO SLOW, TOO FAST OR ONLY ONE SPEED.
Step 1. Check if WINCH SYSTEM/PTO/AIR DRYERS/GPF/HIGH IDLE
circuit breaker has been tripped.
Reset circuit breaker if tripped.
Step 2.
switch to HIGH ENGINE IDLE and press right ENGINE SPEED
CONTROL switch. Check if engine is operating at 1450-1500 rpm.
Notify unit maintenance if engine speed does not increase to
1450-1500 rpm.
Step 3.
Notify unit maintenance if hydraulic fluid level is low.
Step 4.
Notify unit maintenance if transmission fluid level is low.
4.
CABLE HOLD DOWN DOES NOT OPERATE
Check AIR PRESS gage for over 70 psi (483 kPa) on green needle.
Notify unit maintenance if air pressure will not build over 70 psi (483
kPa) or if cable hold down does not work over 70 psi.
3-36