TM 9-2320-387-10
Table 3-1. Troubleshooting (Cont'd).
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
23.1. HYDRAULIC WINCH STOPS DURING NORMAL OPERATION
If fluid level is low add fluid.
Step 2. Ensure winch selector levers are in LOCK LOW GEAR position
If not, move winch selector levers to LOCK LOW GEAR position.
WARNING
Wear leather gloves when handling winch cable.
Do not handle cable with bare hands.
When fully extending winch cable, ensure that
four wraps of winch cable remain on drum at all
times. Failure to do so may cause damage to
equipment or injury or death to personnel.
Direct all personnel to stand clear of winch
cable during winch operation. Failure to do so
may cause damage to equipment and injury or
death to personnel.
Do not even slide gloved hands across winch
cable. Injury can result.
Step 3. Ensure winch cable is not stacked or binding against tiebars or
winch housing.
If winch cable is stacked or binding, remove load from cable, move
winch control levers to FREESPOOL and pay out winch cable by
hand. If unable to pay out winch cable by hand, notify unit
maintenance.
Step 4. Other causes.
Notify unit maintenance.
UP-ARMORED CARRIER
24. WEAPON STATION WILL NOT ROTATE OR LOCK
Step 1. Check for obstructions that may be restricting weapon station
movement.
Remove obstructions.
Step 2. Other causes.
Notify unit maintenance.
25. CARGO SHELL DOOR WILL NOT SEAL PROPERLY
All causes.
Notify unit maintenance.
3-6.2/(3-7 blank)
Change 2