TM 9-2330-205-14&P
Section X. WHEEL, TIRE, HUB, AND DRUM
Page
Page
Wheel and Tire . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Hub and Brakedrum . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
HUB AND BRAKEDRUM
This task covers:
INITIAL SETUP
Materials/Parts Continued
Tools
New hub grease seal
Drift, brass
New hub studs (as required)
Hammer, ball-peen
Woodblocks
Handle, reversible, 3/4-inch square
drive
Jack, hydraulic
Equipment Condition
Jack stand
Screwdriver, flat-tip
Socket, wheel-bearing adjustment
Wrench, box-end, 9/16-inch
References
Materials/Parts
TM 9-214 Care and Maintenance of Anti-
New bearing cups
New hub gasket
ACTION
ITEM
REMARKS
LOCATION
REMOVAL
a. Place jack stand (2) under axle (1).
1.
Axle (1)
Jack stand (2)
b. Lower and remove hydraulic jack (3).
WARNING
All parts of the service brake assembly will be coated with asbestos dust from the brake
linings. A filter mask should be worn whenever working on any assembly components.
Breathing asbestos dust may cause serious damage to health.