TM 9-2330-211-14&P
HUB, DRUM, WHEEL BEARINGS, AND AXLE SEAL (Con't)
4-33.
ACTION
REMARKS
ITEM
LOCATION
NOTE
Remove only studs that are cracked, broken, or damaged.
Using hammer, drive out. Hit stud (20) on short
Stud (20)
Hub (3)
11.
threaded end (21).
CLEANING AND INSPECTION
WARNING
DO NOT handle brakeshoes, brakedrums, or other brake
components unless area has been properly cleaned.
There may be asbestos dust on these components which
can be dangerous if you touch it or breathe it. Wear an
approved filter mask and gloves. Never use compressed
air or a dry brush to clean brake components. Dust maybe
removed using an industrial-type vacuum cleaner. Clean
dust or mud away from brake components with water and
a wet, soft brush or cloth. Failure to follow this warning
may result in serious illness or death to personnel.
Dry cleaning solvent P-D-680 is toxic and flammable.
Always wear protective goggles and gloves, and use only
in a well-ventilated area. Avoid contact with skin, eyes,
and clothes, and DO NOT breathe vapors. DO NOT use
near open flame or excessive heat. The solvent's flash
point is 100F - 138F (38C - 59C). If you become dizzy
while using cleaning solvent, immediately get fresh air and
medical help. If solvent contacts eyes, immediately wash
your eyes and get medical aid.
Clean thoroughly using dry cleaning solvent.
All parts
12.
4-98