TM 9-2330-227-14&P
CONNECTOR RECEPTACLE, 24-VOLT - CONTINUED
ACTION
REMARKS
ITEM
LOCATION
INSTALLATION
Put in place.
Connector
5.
receptacle (2)
Using wire strippers, strip insulation
a.
Eight harness
6. Connector
from ends of wires (7) and leads (8),
wires (7), connector
receptacle (2) and
equal to depth of connectors (9).
receptacle leads (8),
wire harness (6)
and connectors (9)
Slide one end of one connector (9)
b.
onto one of wires (7).
Slide other ends of connectors (9)
c.
onto corresponding leads (8).
Using crimping tool, crimp connectors
d.
(9) at both ends.
Tape each connector (9).
c.
Put in place.
Cover assembly (1)
7. Connector
receptacle (2)
Screw in, and tighten using two 7/16-inch
Two screws (4)
8. Cover assembly
openend wrenches, leaving bottom holes
and nuts (5)
(1), connector
open.
receptacle (2),
and frame (3)
a. Put remaining screw (4) in place.
Remaining
9.
b. Put ground wires (10) in place
screws (4), two
over screw (4).
ground wires (10),
c. Screw on nut (5), and tighten using
and nuts (5)
two 7/16-inch open-end wrenches.
4-75