TM 9-2330-227-14&P
U-BOLTS, RADIUS ROD AND BRACKET, AND SPRING - CONTINUED
ACTION
REMARKS
ITEM
LOCATION
REMOVAL
Using 15/16-inch socket, ratchet handle
Retaining nut (2)
1. Screw (1)
with 1/2-inch drive, and 15/16-inch open-
and nut (3)
end wrench, unscrew and take off.
Using 1/2-inch driftpin and ball-peen
Screw (1)
2. Radius rod (4)
hammer, tap out.
and bracket (5)
Using 3/16-inch fiat-tip screwdriver,
Two retainers (6)
3. Radius rod
take off.
bracket (5)
Using 5/8-inch socket, 4-inch extension,
Setscrew (8)
4. Sleeve
and ratchet handle with 1/2-inch drive,
bushing (7)
unscrew and take out.
a. Using 1-inch drive-pin punch and
Sleeve bushing (7)
5. Radius rod (4)
ball-peen hammer, drive out.
and bracket (5)
b. Repeat steps 1 thru 5 for other end.
c. Take radius rod (4) off.
Using straight-nose slip-joint pliers,
Two cotter pins (10)
6. Two nuts (9)
straighten and take out.
Using 15/16-inch socket, ratchet handle
Two nuts (9)
7. Two screws (11)
with 1/2-inch drive, and 15/16-inch open-.
end wrench, unscrew and take off.
Take out.
Two screws (11)
8. Spring brackets (12)
Using 1 7/16-inch socket, 6-inch
Four nuts (14)
9. Two U-bolts (13)
extension, and ratchet handle with 3/4-
and washers (15)
inch drive, unscrew and take out.
Using ball-peen hammer and 1/2-inch
Two U-bolts (13)
10. Axle (16) and
driftpin, tap out.
radius rod
bracket (5)
Lift off.
Radius rod
11. Spring (17)
bracket (5)
Take out.
Two washers (18)
12. Radius rod
bracket (5)
Two rubber
Using 1 3/4-inch drive-pin punch and
13.
bushings (19)
ball-peen hammer, tap out.
5-64