TM 9-2330-231-14&P
HUB AND BRAKEDRUM MAINTENANCE- CONTINUED
ACTION
LOCATION
ITEM
REMARKS
WHEEL BEARING ADJUSTMENT- CONTINUED
23. Spindle (1)
Adjusting nut (2)
a.
Using wrench 7950946, tighten
until hub just binds.
b.
Back off approximately one-eighth
turn. Hub should not rock and
should turn freely.
24.
Lockwasher (3) and
Using wrench 7950946, install and
locking nut (4)
tighten nut.
25. Hub (5)
Gasket (6), hubcap
Using cross-tip screwdriver, install,
(7), three lock-
washers (8), and
three screws (9)
26. Axle
Jack (10)
Reposition and raise under axle (11).
27.
Jack stand (12)
Remove.
NOTE
FOLLOW-ON MAINTENANCE:
TASK ENDS HERE
TA223921
4-108