TM 9-2330-235-14&P
4-32.
HYDRAULIC BRAKE SYSTEM LINES AND FITTINGS REPLACEMENT (M390C) (Con't).
11. Remove nut (17) and multiple connector (9) from stud (10).
12. If damaged, remove stud (10) and nut (11) from axle.
b.
INSTALLATION
NOTE
If installing lines from multiple connector on axle to wheels, perform steps 1 through 8.
If installing hose from master cylinder to multiple connector on axle, perform steps 9 and 1 0.
1. If removed, install stud (10) through hole in axle. Secure stud to axle with nut (11)
2. Install multiple connector (9) on stud (10) with nut (17).
3. Install multiple connector (14) and spacer (15) on backing plate multiple connector with shouldered washer (13)
and fluid passage bolt (12)
4. Install multiple connector (3) and spacer (2) on backing plate multiple connector with shouldered washer (4) and
fluid passage bolt (5)
5. Connect tube assembly (16) to multiple connector (14) and multiple connector (9).
6. Secure tube assembly (16) to axle with two clamps (6), new lockwashers (7), and screws (8)
7. Connect tube assembly (1) to connector (3) and multiple connector (9).
8. Secure tube assembly (1) to axle with clamp (6), new lockwashers (7).
and screw (8)
9. Connect hose (18) to multiple connector (9) on axle.
10. Connect hose (18) to reducer (20) at master cylinder (19)
FOLLOW-ON TASKS:
TA505024
4-71