TM 9-2330-246-14
4-80. RADIUS RODS MAINTENANCE (Con't).
d.
ASSEMBLY
1.
Install two setscrews (3) in connectors (11 ). Do not
tighten setscrews.
2.
Install two connectors (11) on radius rod (4) using
two screws (12), new Iockwashers (13), and nuts
(14).
e.
INSTALLATION
Position radius rod (4) in spring holder (2) and radius rod bracket (9)
1.
2.
At each end, position one flatwasher (5) on each side of radius rod (4) and slide sleeve bearing (10) into place.
Rotate sleeve bearings so that setscrews (3) enter cross holes in sides of sleeve bearings. Tighten setscrews.
Install bushing (6) and outer retainer (7) on each end of sleeve bearings (10).
3.
4.
Secure each end of radius rod (4) with screw (1) and two nuts (8).
.
f.
ADJUSTMENT
NOTE
Roadside radius rod is the only adjustable one.
1.
Remove outer wheels (para 4-70). Remove access cover from each hub so that center mark on end of axle
TA700287
4-194