TM 9-2330-246-14
4-81. RADIUS ROD BRACKET AND BUMPER REPLACEMENT
This Task Covers:
Removal
Installation
a.
b.
/n/f/a/ Setup:
Tools/Test Equipment:
Equipment Conditions:
General mechanic's tool kit
a. REMOVAL
1.
Loosen setscrew (8) in radius rod (2).
2.
Remove two nuts (6) from screw (1),
Remove screw (l), two outer retainers (5), two
3.
bushings (4), sleeve bearing (10), and two
flatwashers (3).
4.
Remove radius rod bracket (7),
Remove bumper (9) from radius rod bracket (7).
5.
INSTALLATION
b,
Install bumper (9) in radius rod bracket (7).
1.
2.
Position radius rod bracket (7) for installation.
Position one flatwasher (3) on each side of radius rod (2) and slide sleeve bearing (10) into place. Rotate sleeve
3.
bearing so that setscrew (8) will enter cross hole in side of sleeve bearing, Tighten setscrew.
4.
Install bushing (4) and outer retainer (5) on each end of sleeve bearing (10).
5.
Secure radius rod (2) to radius rod bracket (7) with screw (1) and two nuts (6).
FOLLOW-ON TASKS:
If roadside radius rod bracket was replaced, adjust roadside radius rod (para 4-80).
TA700289
4-196