TM 9-2330-246-14
4-131. HEATER FUEL LINES AND FITTINGS REPLACEMENT (M373A2D AND M373A5)
(Con't).
3.
Connect fitting (8) to bulkhead connector (19)
4.
Install each plate (23) on semitrailer floor (22) using five screws (24). Ensure that grommet (7) is properly seated
between plates.
Install each of three clamps (27) on brackets (4) using bolts (25), flatwashers (26), new Iockwashers (5), and
5.
nuts (6).
6.
Underneath semitrailer, connect fitting (18) to bulkhead connector (19).
c.
BULKHEAD CONNECTOR REMOVAL
1.
From underneath semitrailer, disconnect fitting (18) from bulkhead connector (19) and allow fuel to drain.
2.
Inside semitrailer, remove five screws (24) from each plate (23). Remove plates.
Disconnect fitting (8) from bulkhead connector (19).
3.
4.
Remove nut (9), flatwasher (10), and gasket (11) from bulkhead connector (1 9). Discard gasket.
Remove bulkhead connector (19), flatwasher (20), and gasket (21) from underneath semitrailer. Discard gasket.
5.
TA700376
4-315