TM 9-2330-246-14
LANDING GEAR REPAIR (EARLY MODEL) (Con't).
5-5.
7.
Rotate lower leg (29) to aline gib (34) with contact groove in upper leg (20). Lubricate gib contact groove with
grease. Install gib, spring clip (33), and plug (32).
8.
Install shaft (17), gear cluster (38), woodruff key (13), gear cluster (8), and flatwasher (6) in gearbox (37).
Install pin (18) to secure gear cluster (38) to shaft (17).
9.
10.
Install new spring pin (19) to secure gear cluster (8) to shaft (17).
11.
Install shaft (11 ) and bevel gear (5) in gearbox (37).
12.
Install pin (12) and new spring pin (14) to secure bevel gear (5) to shaft (1 1).
13.
Make a preliminary operation check by turning shaft (11) to retract and extend lower leg (29).
If removed, install two lubrication fittings (35 and 36) in upper leg (20).
14.
15.
Install ball bearing (1 O) and spring (9) in gearbox (37).
16.
Pack gearbox (37) with grease.
17.
Install new gasket (3) and cover (2) on gearbox (37) using four screws (l).
18.
Lubricate axle (27) with grease. Install axle through lower leg (29).
19.
Install two wheels (24) and wheel caps (26) on axle (27) using bolt (25) and nut (28).
Make final operational check. Ensure that crankshaft maintains its setting during high and low speed operation.
20.
.
FOLLOW-ON TASKS:
Section Ill. UNIT HEATER MAINTENANCE
UNIT HEATER REPAIR.
5-6.
For information on repair of unit heater refer to TM5-4520-233-14 for the M373A2D and TM 5-4520-241-14 for
the M373A5.
5-11/(5-12 Blank)