MAINTENANCE FUNCTIONS (Con't).
j. Overhaul. That maintenance effort (service/action) prescribed to restore an item to a completely
serviceable/operational condition as required by maintenance standards in appropriate technical publications (i.e.,
DMWR). Overhaul is normally the highest degree of maintenance performed by the Army. Overhaul does not normally
return an item to like new condition.
k. Rebuild. Consists of those services/actions necessary for the restoration of unserviceable equipment to a
like new condition accordance with original manufacturing standards. Rebuild is the highest degree of materiel
maintenance applied to Army equipment. The rebuild operation includes the act of returning to zero those age
measurements (hours/miles, etc.) considered in classifying Army equipment/components.
EXPLANATION OF COLUMNS IN THE MAC, SECTION Il.
a. Column 1, Group Number. Column 1 lists functional group code numbers, the purpose of which is to
identify maintenance significant components, assemblies, subassemblies, and modules with the next higher
assembly. End item group number shall be "00."
b. Column 2, Component/Assembly. Column 2 contains the names of components, assemblies,
subassemblies, and modules for which maintenance is authorized.
c. Column 3, Maintenance Function. Column 3 lists the functions to be performed on the item listed in
Column 2. For a detailed explanation of these functions, refer to paragraph B-2.)
d. Column 4, Maintenance Level, Column 4 specifies, by the listing of a work time figure in the appropriate
subcolumn(s), the level of maintenance authorized to perform the function listed in Column 3. This figure represents the
active time required to perform that maintenance function at the indicated level of maintenance. If the number or
complexity of the tasks within the listed maintenance function vary at different maintenance levels, appropriate work
time figures will be shown for each level. The work time figure represents the average time required to restore an item
(assembly, subassembly, component, module, end item, or system) to a serviceable condition under typical field
operating conditions. This time includes preparation time (including any necessary disassembly/assembly time),
troubleshooting/fault location time, and quality assurance/quality control time in addition to the time required to
perform the specific tasks identified for the maintenance functions authorized in the Maintenance Allocation Chart. The
symbol designations for the various maintenance levels are as follows:
Unit (Operator or Crew)
Unit (Organizational) Maintenance
Direct Support Maintenance
General Support Maintenance
e. Column 5, Tools and Equipment. Column 5 specifies, by code, those common tool sets (not individual
tools) and special tools, TMDE, and support equipment required to perform the designated function.
f. Column 6, Remarks. This column shall, when applicable, contain a Ietter code, in alphabetic order, which
shall be keyed to the remarks contained in Section IV.
EXPLANATION OF COLUMNS IN TOOL AND TEST EQUIPMENT REQUIREMENTS,
a. Column 1, Tool or Test Equipment Reference Code. The tool and test equipment reference code
correlates with a code used in the MAC , Section II, Column 5.
b. Column 2, Maintenance Level. The lowest level of maintenance authorized to use the tool or test