TM 9-2330-247-14&P
4-26. CHASSIS WIRING HARNESS (Con't)
ACTION
ITEM
REMARKS
LOCATION
CIRCUIT MARKER BAND REPLACEMENT
26.
Marker band (29)
Wire lead (22)
Using in. flat-tip screwdriver, open tab ends and
take off.
Note number on marker band (29) and
discard.
27.
New marker
a. Using etcher, etch proper number.
band (29)
If number is missing or illegible, refer to
b. Place on wire lead (22) and bend tab ends over
wire using crimping tool.
INSTALLATION
Lay out over trailer crossbeams
28.
Chassis wiring
Frame (7)
harness (3)
Feed through proper frame holes (8).
29.
Connectors
Chassis wiring
(14 and 19)
harness (3)
Place clips on frame and line up screw holes.
Two clips (21) and
30.
Frame (7)
two rear corner
clips (12)
31.
Two clips (21),
a. Put screws through frame and clip screw holes.
Eight screws (11),
b. Put Iockwashers on nuts and screws and tighten
nuts (9), and
two rear corner
Iockwashers (10)
clips (12),
using no. 2 cross-tip screwdriver and
in.
open-end wrench.
and frame (7)
NOTE
When connecting chassis wiring harness connectors to light
assemblies and intervehicular cable connectors, ensure that
Apply insulating compound to male connectors
Intervehicular cable
12 connectors
32.
(19), Put together connectors and push into clips
(18 and 19)
connector leads (17)
(21),
and chassis wiring
harness leads (20)
TA701060
4-32