TM
9-2330-251-14&P
4-33. BLEEDING HYDRAULIC BRAKE SYSTEM (M416A1).
This Task Covers:
Pressure Bleeding
b.
Manual Bleeding
a.
Initial Setup:
Tools/Test
Equipment:
Materials/Parts:
General mechanic's tool kit
q
q
Common no. 1 shop set
q One locknut
q Drain pan
q Plastic tubing
q Pressure bleeder
q Quart container
Personnel Required: Two
References:
TB 43-0002-87
q
q TM 9-4910 -709-14&P
a.
MANUAL BLEEDING
NOTE
This procedure is typical for both left and right wheels.
Manual bleeding procedure should be used only if a pressure bleeder is not
available.
Fluid level of master cylinder (2) should be checked frequently during bleeding
procedure and fluid added as required. Failure to keep master cylinder filled will
allow air to enter hydraulic brake system.
A suitable container should be used to catch any draining brake fluid. Ensure that
all spills are cleaned up.
Remove locknut (1) and screw (5) securing
1.
shock absorber (4) to channel assembly (3).
Discard locknut.
TA503932
4-49