TM 9-2330-285-14&P/TO 36A11-21-10-1
LUBRICATION CHART
1. For lubrication under normal conditions, refer to the lubrication chart on the
following page.
2. For instructions on lubrication in weather below 0F (-18C), refer to FM 9-207.
3. For lubrication before and after fording, refer to TM 9-238.
4. After operating in mud, dust, sand, or other unusual conditions, clean and inspect
all lubrication points. Lubricate dolly set in accordance with the lubrication chart.
LUBRICATION CHART
DOLLY
SET,
TRANSPORTABLE
SHELTER
M720
Dotted leader lines indicate lubrication is required on both sides
Intervals (on-condition or hard-time) and the related man-hour
of the equipment.
specified is the time you need to do all the services prescribed
for a particular interval. Change the hard-time interval if your
WARNING
lubricants are contaminated or if you are operating the equip-
ment under adverse operating conditions, including fording.
Drycleaning solvent PD-680 used to clean parts is
potentially dangerous. Do not use near an open
The interval may be extended during periods of low activity. If
flame or excessive heat. Flash point of solvent is
extended, adequate preservation precautions must be taken.
138 F (58"C).
NOTE
Clean all fittings and the area around lube points with dry-
cleaning solvent PD-680 or equivalent, before lubricating.
LV is Localized View.
TOTAL MAN-HOURS*
MAN-HOURS
INTERVAL
1.5
M
2.5
s
6.0
A
`The time specified is the time required to perform all services at the particular level.