TM 9-2330-285-14&P/TO 36A11-21-10-1
ORGANIZATIONAL PREVENTIVE MAINTENANCE CHECKS AND SERVICES - CONTINUED
A-Annually
S-Semiannually
Q-Quarterly
ITEM TO BE INSPECTED
INTERVAL
PROCEDURE: CHECK FOR AND HAVE REPAIRED, FILLED,
ITEM
REPLACED, OR ADJUSTED AS NEEDED
NO.
STEERING
9
tie rod ends (1) for broken seals or looseness.
a. Check
tie rod (2) for bends.
b. Check
kingpins (3) for looseness.
c. Check
steering arm pivot pin (4) for looseness.
d. Check
ELECTRICAL SYSTEM
10
a. Replace or repair inoperative or damaged lights.
TROUBLESHOOTING P R O C E D U R E S
Section
V
ORGANIZATIONAL
Page
Page
Explanation of Columns . . . . . . . . . . . . . . . .
4-13
Organizational
Introduction . . . . . . . . . . . . . . . . . . . . . . . . . .
T r o u b l e s h o o t i n g Table . . . . . . . .
4-14
4-12
Symptom index . . . . . . . . . . . . . . . . . . . . . . .
4-13
INTRODUCTION
This section lists the common malfunctions that may be found during the operation or maintenance of
the dolly set or components. Perform the test/inspection and corrective action in the order listed.
This table cannot list all the malfunctions that may occur, nor all test or inspections and corrective ac-
tions. If a malfunction is not listed, or if it is not corrected by the listed corrective action, notify your
supervisor.
TA 221656