TM 9-2330-285-15&P/TO 36A11-21-10-1
Page
Page
Master Cylinder . . . . . . . . . . . . . . . . . . . . . . . 4-116
Air Brake System . . . . . . . . . . . . . . . . . . . . . .
4-120
Service Brake . . . . . . . . . . . . . . . . . . . . . . . . . 4-96
Handbrake System . . . . . . . . . . . . . . . . . . . .
4-90
4-118
Wheel Cylinder . . . . . . . . . . . . . . . . . . . . . . .
Hydraulic Brake Lines . . . . . . . . . . . . . . . . . .
4-104
HANDBRAKESYSTEM
This task covers:
INITIAL SETUP
Materials/Parts
Tools
New cotter pins
1/2-inch wrench (two required)
Cross-tip screwdriver
Diagonal cutting pliers
Equipment Condition
7/8-inch wrench (two required)
ACTION
ITEM
REMARKS
LOCATION
LEVER REMOVAL
NOTE
Step 1 applies to late models only. Step 2 applies to early
models only.
1 Bottom side of
Lever (1), three
Remove using a 1/2-inch wrench.
Catch spacers (4) as they fall out
rear axle beam
screws (2), three
of lever (1).
washers (3) and
three spacers (4)
Remove using two 1/2-inch wrenches.
Lever (1), three
2 Rear brake
screws (5), three
Catch spacers (8) as they fall out of
chamber bracket
washers (6), three
lever.
nuts (7) and three
spacers (8)
NOTE
Steps 3 and 4 apply to all models.