TM 9-2330-285-14&P/TO 36A11-21-10-1
SERVICE BRAKE
This task covers:
INITIAL SETUP
Tools
Materials/Parts
Horseshoe clip, handbrake lever
Brake spring pliers
retaining
Brake shoe adjusting tool
Slip joint pliers
Equipment Condition
Diagonal cutting pliers
Brake shoe retaining spring tool
Flat-tip screwdriver
Hub and brake drum removed
ACTION
REMARKS
LOCATION
ITEM
DISASSEMBLY
WARNING
Brake lining material contains asbestos. Breathing of dust
from lining; is extremely hazardous. Wear a filter-mask
whenever working with brake shoes.
Remove using brake spring pliers.
Two springs (1)
1 Service brake
assembly
a. Pull out guide (2) and remove together
Guide (2), cable
2
with cable (3).
(3), retainer (4)
b. Take off retainer (4) and washer (5).
and washer (5)
Remove parts.
Two washers (6),
3
a. Push in on washer (6) using spring
two springs (7),
retainer tool.
two washers (8)
b. Rotate washer (6) about 90 degrees and
and two pins (9)
release it.
c. Take pins (9) out from the rear.
NOTE
Since the front dolly does not have a handbrake system, the
two front service brakes will not contain struts (14), spring
(15) and lever (16). If working on the front, dolly service
brakes, omit steps 5 and 6.