TM 9-2330-285-14&P/TO 36A11-21-10-1
S e c t i o n XIV HYDRAULIC LIFT SYSTEM MAINTENANCE
Page
Page
4-166
Lift Cylinders . . . . . . . . . . . . . . . . . . . . . . . . .
System Bleeding . . . . . . . . . . . . . . . . . . . . . . 4-168
Pump . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
4-163
PUMP
This task covers:
INITIAL SETUP
Tools
Tools - Continued
5/8-inch open end wrench
(two required)
9/16-inch open end wrench
1/2-inch box wrench
Socket, 1/2-inch by 1/2-inch drive
ACTION
LOCATION
ITEM
REMARKS
SERVICING
1 Hydraulic pump (1)
Filler cap (2)
Take off using 5/8-inch open end wrench.
2
Reservoir (3)
Look into reservoir. Make sure oil level is
at least 1/2 inch (1.27 cm) from the top.
Add oil if necessary. (See page 4.2.)
3
Filler cap (2)
Put on using a 5/8-inch open end wrench.