TM 9-2330-285-14&P/TO 36A11-21-10-1
STEERING KNUCKLE - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
BUSHING INSTALLATION
3 Knuckle (1)
Two bushings (2)
Install bushings using an arbor press and
bushing driver fixture.
Be sure that holes in bushings are
alined with holes in knuckle where the
grease fittings (3) go.
NOTE
The bushings (2) supplied are somewhat smaller than the
kingpin (4). After step 3, the bushings must be reamed and
fitted to the kingpin (4). After fitting the bushings (2) to
the kingpin (4) all parts must not be interchanged but rather
supplied to organizational maintenance as a matched set for
installation on the dolly set.
4
Two bushings (2)
Using a reamer, fit bushings (2) to king-
pin (4).
and kingpin (4)
The kingpin (4) should slide freely
into the bushings with no noticeable
looseness from side to side.
Install using a 5/16-inch wrench.
Two fittings (3)
5
TASK ENDS HERE