TM 9-2330-294-14
wiring harness on semitrailer No. 1 through 200
and clamps in place by turning screws a few threads
only. Disconnect wiring harness from side clearance
into pad holes. Harness is removed from the front of
lights and from clearance light ground connections.
semitrailer. Starting at the rear of semitrailer, pull
Disconnect main wiring harness from magnet valve
harness end branches forward through holes in frame
on semitrailer No. 1 through 200 only. Disconnect
members and continue progressively forward to the
wiring harness from low-pressure warning switch.
gooseneck. Pull wiring harness forward through
Remove composite light cable guard and disconnect
holes in gooseneck frame members and through hold
wiring harness from composite light connections and
rear utility outlet connection. Disconnect wiring
in forward mounting bracket. Remove grommets to
facilitate operation.
harness from rear marker lights. Remove screws and
Figure 5-3. Typical main wiring harness clamp installation.
mounting bracket. Thread branches and main stem
(2) Repair. For replacement of shell assem-
blies, terminals and connectors refer to paragraph 4-
of harness through holes in gooseneck frame
members and bed frame members. Apply insulating
defective wiring.
compound (MIL-S-8660 or 801362 (19203) to male
(3) Installation. Thread wiring harness,
shells at all electrical connections before mating with
branches first, rearward through hole in gooseneck
female shells. This compound aids insulation and