TM 9-2330-294-14
e. Check lining installation with a 0.002-inch
6-19. Inspection and Repair
feeler gage. to assure lining and shoe contact.
a. Inspection. Inspect shoe and replace
if dis-
torted, badly scored, or cracked more than
0.375
inch through new lining. A new lining is
0.750
inch thick.
b. Repair. Replace damaged or defective
parts.
6-20. Assembly
NOTE
Do not use combination linings.
a. Make sure lining and shoe contact faces are
clean.
b. Clamp lining firmly to shoe. Aline rivet holes
in both pieces and locate the "C" clamps as close
to rivet holes as possible.
c. Drive riveta squarely into holes with a 7/16-
inch flathead drift.
d. Form rivet heads with suitable tubular rivet
Section VII. BRAKE AIR CHAMBER REPAIR
This section provides information to direct and
CAUTION
general support maintenance personnel for the
disassembly, cleaning, inspection, repair and
All internal components of the brake air
assembly of the brake air chambers. Repair of the
chamber assemblies used on semitrailer No.
brake air chambers consists of replacement of worn
1 through 200 and those used on semitrailer
or damaged parts.
No. 201 and on are not interchangeable
Change 2