TM 9-2330-297-14&P
RESISTORS
This task covers:
b. Installation (page 4-35)
INITIAL SETUP
Tools
Materials/Parts
Screwdriver, flat-tip
Resistor
Wrench, box, 3/8-inch
ACTION
LOCATION
ITEM
REMARKS
NOTE
The following removal and installation procedure is for one resistor. Removal and installation of other resistors
are similar.
REMOVAL
1. Chassis front
Resistor box (1)
a. Using screwdriver, remove two
crossmember
screws (2).
b. Pull resistor box (1) out of chassis
front crossmember.
2. Resistor box (1)
Resistors (3)
b. Using screwdriver and 3/8-inch wrench,
remove screws (5), nuts (6), and
spacers (7)
c. Unstack and remove bad resistor.
Discard bad resistor.
Change. 1 4-34.2