TM 9-2330-356-14
c.
(2) Attach light to hose trough with two screws
Cleaning and Inspection.
and nuts.
(1) Wipe dirt and other matter from light.
(2) Inspect light for broken or cracked lens and
corroded socket.
assembly and control panel.
(3) Inspect body and switch for damage.
(4) Replace terminal on end of wire and connect
(4) Replace damaged parts or replace light.
to control panel wiring harness.
Installation.
d.
(5) Connect battery ground negative cable
(1) Thread wire through conduit into control
panel box.
Section X. MAINTENANCE OF HOSE REEL ELECTRICAL SYSTEM
(6) Cable assemblies
b.
Repair. The repair of most of the wiring can be
WARNING
performed without removing the cables from the conduit.
When troubleshooting an electrical malfunc-
(1) Clean ends of cables with a damp cloth.
tion or performing electrical maintenance,
ALWAYS disconnect intervehicular electrical
(2) Check ends of cables for frayed insulation or
cable from semitrailer, and negative battery
broken wires. Tape or replace frayed wires.
cables at batteries, Failure to follow this warn-
ing may create a spark and explosion, result-
(3) Inspect wires for bent, broken, or missing
ing in serious Injury or death to personnel.
terminals. Replace missing or damaged terminals.
a.
General. The hose reel electrical system consists
c.
Replacement of Wiring. Use figures 4-46 and 4-47
as guides in replacing cables. Remove the cover on any
references.
electrical component to gain access to lead terminals. Pull
old lead from conduit and install new lead with a lacing
(1) Buss fuse
wire, if necessary.
Replacement of Conduit. Use figures 4-48 and 4-49
d.
as guides in replacing conduit. Remove cables from
conduit to be replaced. Loosen conduit connectors on
each end of conduit and remove conduit. The conduit
(4) Junction box on hose reel motor (2)
between engine compartment and junction box can be
(5) Hose reel rewind switches