TM 9-2330-356-14
WARNING
With hose pulled from hose reel, the reel is
under spring tension. Be careful not to
release hose reel when removing hoses.
Personal injury could result.
(f) Disconnect hoses from elbows on the
TA099873
Replacement.
(d) Attach 45 elbow and breakaway fitting
half to new hose.
(f) Loosen hose reel lock and rewind hose
(g) Install underwiring nozzle onto hose
c.
Replacement of Hose on Deadman Hose Reel (M970
TA099874
and M970A1).
(1) Removal.
Hose Reel.
(2) Installation.
(a) Pull hose reel out far enough to remove
deadman control from hoses.
(a) Thread red hose through opening in
(b) Remove the two screws and nuts on the
assembly. Attach green hose to IN port of valve assembly.
(b) Replace valve assembly in handle guard
(c) Disconnect the two hoses from the valve
of deadman control. Secure with two screws and nuts.
assembly.
(c) On green hose, replace the hose ball
(d) Remove the hose ball stop from hose by
stop about 12-inches from the deadman control.
removing the two screws securing the two halves together.
(d) Thread the two hoses through opening
NOTE
(e) Attach green hose to outside elbow
Do not unwind hose reel fully. Hose reel may
not release to rewind.
elbow.
(e) Pull remaining hoses from hose reel.
(f) Pull hoses to release latch on hose reel
Make sure you can reach the ends of the hoses.
and rewind the hoses.