TM 9-2330-356-14
Hose Reel Cabinet (M969, M969A1, M970,
(b) Disconnect the control cable from the
and M970A1)
NOTE
(c) Remove the cabinet door and frame by
removing the ten capscrews, flatwashers, and self-locking
The hose reel cabinet must be removed to
nuts. Two people will then be able to lift the door and
remove the hose reels.
frame off.
Tag all lines as they are disconnected for
ease of installation.
(d) Disconnect three lines on the parking
a.
Removal.
(e) Disconnect line to deadman hose reel.
(1) Position semitrailer on level surface with
front resting on landing gear.
(f) Disconnect line to the flow control
(2) Open valves and drain piping in cabinet area.
valve.
(3) Disconnect the negative cables from
(g) Pull disconnected lines through the hole
batteries.
in the rear of cabinet.
(4) Disconnect the lead inside the electrical
(7) On the M969 and M969A1, disconnect the
two meter inlet pipes by removing the split couplings from
(5) Disconnect the conduit at the electrical
inside the cabinet. On the M970 and M970A1, disconnect
the meter inlet pipe by removing the split coupling from
outside the rear of cabinet.
(6) On the M970 and M970A1 only, perform the
following steps:
(8) On the M969 and M969A1, remove the
cabinet door and frame by removing the ten capscrews,
(a) Disconnect the line that runs to the
washers, and self-locking nuts. Two people will then be
the rear of the cabinet. Pull line into the cabinet.
able to lift the door and frame off.