TM 9-2330-356-14
(4) Turn engine clockwise until the remaining
(4) Using the 5/8-inch socket, extension, and
two bolts and four washers can be installed.
socket wrench, turn engine clockwise until the two
remaining bolts can be removed.
(5) Apply thread sealant to two remaining bolts,
and install two bolts and four washers. Tighten bolts to
(5) Remove the two remaining bolts and washers.
25 lb.-ft.
intermediate housing and remove belt.
pulley.
(7) Install alternatorand adjust drive belt tension
Buss Bar
6-21.
a.
b.
(1) Use a bench grinder to remove crimped end
of rivet.
(2) Use a hammer and punch to drive rivet from
buss bar and fuse clip.
(3) Install fuse clip to the buss bar with a rivet.
Use a rivet punch to install rivet.
c.
Direction.
b.
Installation (Fig. 6-11).
(2) Position pulley and belt in intermediate
housing between the two hubs.
CAUTION
Be sure curved side of washers are against
flex plates. Bolts holding pulley to flex plates
must be tightened to 25 Ib.-ft.
(3) Apply thread sealant to two holes, and install
two bolts and four washers to hold flex plates to pulley.
Tighten bolts to 25 lb.-ft.
6-13/(6-14 Blank)