TM 9-2330-356-14
With engine laid on its side, install tappets (27,
b.
c. Install key (17, fig. 7-31) on
camshaft (14). Press
on gear (16) and install retaining ring (15).
Install camshaft assembly (14) in engine, and
d.
ensure that tappets (27) are in place. Aline timing marks
retaining washer (8) and retaining ring (7). Use a pinch bar
gage, measure the gap between the camshaft gear and
crankshaft retainer washer. Gap should be .007- to
.039-inches.
TA502326
Figure 7-38. Timing Gear End Play.
k.
l
m.
a. Fill flyball recesses with grease (item 16, Appen-
dix E) and install flyballs.
Position governor cup on shaft and install
b.
retaining ring.
TA502325
Timing Marks.
a. Pack the cavity between the two oil seal lips (6,
e. Turn engine with oil base down and install push
b.
Tape keyway and sharp edges on crankshaft to
protect the oil seal during installation.
f.
c. Mount
gear cover (5, fig. 7-31) on
engine using
g. Install crankshaft gear retaining washer (8,
new gasket(6), screws (1 and 3), and lockwashers (2 and 4).
fig. 7-31) and retaining ring (7) on
the crankshaft.
Before tightening screws, ensure that stop pin is in
governor cup hole.
h.
d.
i.
e.
j.