TM 9-2330-356-14
c.
7-53. Engine Junction Box and Electrical Wiring
a. Clean all gasket material from oil filter adapter
(19, fig. 7-20) and cylinderblock. Attach oil filter adapter
(19) and new gasket (20) to cylinder block with three
capscrews (17) and lockwashers (18). Tighten capscrews to
45-50 lb.-ft.
a.
Connect lead from control switch terminal on
Attach all oil lines to oil filter adapter
b.
Position solenoid on bottom cylinder pan and
b.
install two screws. Be sure ground lead is installed by one
c.
of the screws.
Install elbow (15). Tighten elbow securely to
d.
c.
position 90 right of top center.
e. Attach oil cooler hoses 10 oil filter adapter
a.
Install injector lines (7).
b.
Install manifold (4) and return lines (5).
f
c.
Install injector nozzle return lines (3).
a.
a.
Using screws (13), lockwashers (14), and nuts (15),
b.
Connect oil line (4) to adapter (5) and restricted
attach governor control bracket (12) to engine backplate.
tee (3).
b. Insert end of throttle rod (7) through two washers
c.
(20) and into hole in control arm (19). Secure with cotter
Connect oil line (2) to adapter (1) and restricted
pin (5).
tee(3).
c. Attach throttle cable (11) to throttle arm (10)with
Connect oil line (9) to elbow (10) on oil filter
d.
clevis pin (9) and cotter pin (8).
adapter (19) and restricted tee (14).
NOTE
If new ball joints are used on linkage, position
a.
the new joints to obtain the same length or
1/32 inch more than the old linkage (one turn
equals 1/32 inch). If old linkage length is not
Position gasket (4) on filler tube (3).
b.
available, position new ball joints about
midway on each end of linkage, then lengthen
Position both gasket and filler tube on engine
c.
1/8-inch.
and tighten.
d.
Attach governor arm (3) to governor shaft (4) and
install spring (17). Attach opposite end of governor arm to
d.
governor linkage (1). Connect governor linkage (1) to
filters (2) onto engine crankcase. Install three capscrews
injector pump (2).
(3) and lockwashers (4), and tighten.
a. Assemble items 5-13 in
order shown in
figure
7-13.
a. Install exhaust manifold (4) and four new gaskets
(5) to cylinder heads. Secure with four lock tabs (1), eight
b.
Install assembled pressure switch by securing
capscrews (2), and eight washers (3). Tighten capscrews
switch bracket (10) with two capscrews (3) and washers(4).
evenly to 1315 lb.-ft. Bend lock tabs (1) up to prevent
capscrews (2) from loosening.
c.
Connect two leads (1 and 2) to high temperature
switch.
b.
d.
Remove block from louvers on air shutter.