TM 9-2330-357-14&P
5-11. OUTRIGGER ACTUATOR ASSEMBLY REPAIR (Con't).
12.
Bend tab (14) on lockwasher (17) away from slot (15) in locknut (16).
13.
Remove locknut (16) and lockwasher (17).
NOTE
Socket head screws used as jackscrews in step 14 should be in. Head
and 2 in. (5cm) long.
14.
Install three socket head screws (18) into
tapped holes in output gear (19).
15.
Rotate output gear (19) to position where
surface of gear housing (6) is directly below
each of three socket head screws (18). Tighten
all three socket head screws evenly and
remove output gear.
16.
If damaged, remove lower gearshaft bearing
(20) from gear housing (6).
5-30